The Avanti J-HC High Capacity Centrifuge provides you with a complete solution for batch bioprocessing. A maximum of 9 Liters can be spun at speeds of 5,000 rpm and 7,480 x g for greater sample throughput. This allows processing of up to 36 Liters per hour when harvesting bacteria. Enhanced operator safety is provided with disposable HarvestLine System Liners.

SPECIFICATIONS:

UNSPSC:	41103905
Height:	86 cm (34 in); with door open 152 cm (59.9 in)
Width:	71 cm (28 in)
Depth:	86 cm (34 in); 102 cm (40.25 in) including air diverter extending from back panel
Weight:	300 kg (660 lb)
Approximate Acceleration Time:	Maximum or slow
Approximate Deceleration Time:	Maximum, slow, timed (1 to 10 min from 500 to 0 rpm), or off
Maximum Heat Dissipation into Room under Steady-State Conditions:	2.0 kW (6,900 Btu/hr)
Noise Level 1 Meter in Front of Centrifuge:	<= 60 dBA
Set Speed:	100 to 10,000 rpm (ARIES rotors: 1000 to 10,000 rpm) in 10-rpm increments; or RCF from 200 g to maximum for the installed rotor (in 10 g increments)
Set Temperature:	-10° C to +40° C in 1° C increments
Set Time:	1 min to 99 hr 59 min (timed run), total centrifugal effect (g-seconds), or continuous (hold)
Speed Control:	actual rotor speed ±25 rpm; g force control sets speed to the nearest 50 rpm
Temperature Control:	± 2° C of set temperature (from 1,000 to 10,000 RPM)
Ambient Temperature Range:	15° C to 40° C
Clearances Required:	7.6 cm (3.0 in) sides; 16.0 cm (6.25 in) rear
Humidity Restrictions:	< 95% (noncondensing)
Pollution Degree:	2
Rotor Chamber Diameter:	58.4 cm (23 in)
Time -- Actual Display:	Indicates run time remaining (timed run), g-seconds setting and time remaining to accumulate set g seconds (g-seconds run), or elapsed time (hold run)
Finish:	Polycarbonate overlay on top surface of door; urethane paint on door edges and lower surface. Control panel: polyester with polycarbonate coating overlay

Availability of adapters, rotors, tubes and bottles, parts and accessories, software.